Thank you Wisdom for choosing our company's automatic hand dryer. I am confident that you will be infinitely gratified after purchasing. From now on, you will be our guest of honor. We will provide you with disruptive services.

Product appearance

Features

1. Intelligent judgment, 100% high sensitivity.
2. Elegant, beautiful and novel new design.
3. The heating element is double protected to avoid overheating and overheating.
4. Low noise and large air volume structure.
5. 1~10 minutes timeout limit to avoid interference and malfunction.
6. Set up anti-vandalism device, which will automatically cut off the power supply and automatically resume work after removal
7. Work continuously for 1~3 seconds, so that the power will not be cut off due to the temporary leaving of the hand.
8. Brand-new heating element design, uniform hot air.
9. The installation is simple and convenient, suitable for hotels, office buildings and other advanced places.
10、technical parameter:

Instructions

1. After the hand dryer is installed, it is in working condition after turning on the power. (Just turn on the power, the air outlet of the hand dryer will automatically work once, which is a normal phenomenon)
2. When your hand is within 20cm of the air outlet of the hand dryer, the hand dryer will automatically work and send out hot air for you to dry your hands.
3. When you leave the hand dryer, it will keep working for 1-3 seconds and then stop and be in standby mode.

Precautions

1. The machine is installed on a firm and non-vibrating wall.
2. It is forbidden to collide with hard objects or wash with water.
3. It is forbidden to scrub the shell with corrosive liquids such as banana water and alcohol, or scratch with a sharp object, so as not to affect the appearance.
4. If the shell is contaminated, cut off the power supply and clean it with a damp towel and soapy water to prevent water dripping into the machine to avoid short-circuit due to moisture in the future.
5. Non-professionals should not disassemble and repair by themselves.
6. Add a few drops of lubricant to the bearings at both ends of the motor every season.
7. This product must be connected to the ground wire.
8. If the power cord is damaged, it must be replaced by the manufacturer or its maintenance department or similar full-time personnel to avoid danger.
9. Do not use this appliance near water.
Products are subject to change without notice.
10. In order to avoid the possibility of failure, please do not install the product on stainless steel walls, other high-intensity reflective surfaces or other infrared sensors.

Installation Notes

<一>、Place the hand dryer according to the distance from the wall and the height from the ground as shown in the figure.

<二>、Fix the mounting iron bar of the hand dryer with screws.

<三>、Just buckle the hand dryer directly.

Note: When installing, the distance between the lower end of the product and the ground should be higher than 1.1 meters

Common faults and solutions

After-sales service

If the user encounters any difficulties during use, please contact the company's after-sales service center or the seller.